Indoor pools are the hardest rooms a mechanical contractor will ever work in. Warm water, humid air and pool chemicals are constantly working against the equipment and against the building itself. Mountain Mechanical NY keeps swim schools, YMCAs and residential pool floors comfortable, dry and protected across Long Island, New York City, Westchester and New Jersey.

Our pool work is led by Richard Roman, Mountain Mechanical’s chief technical point person for indoor pool dehumidification. Rich runs every pool project from the first walk-through to final start-up, working directly with the equipment manufacturers’ factory support.

Indoor swim school pool with climate-controlled air
A swim school natatorium we keep at its target temperature and humidity year-round
New rooftop pool unit being lifted by crane
A new rooftop unit for a swim school, lifted by crane and set on a prepared curb

See our pool project photos → Crane lifts, new rooftop units, exhaust fans and dehumidifier work from our crews.

What We Do for Indoor Pools

  • Pool dehumidifier service, repair and replacement: PoolPak, Desert Aire, Seresco and similar units, including compressors, blowers, refrigeration and reheat circuits
  • Dedicated outdoor air systems (DOAS) and makeup air sized for the pool, deck and spectators
  • Corrosion-rated exhaust fans for pool, chemical storage and pump rooms
  • Pool water and space heating: boilers, heat exchangers and pool heating loops
  • Controls, sensors and remote monitoring so problems are caught before they reach the building
  • Air balance: holding the pool slightly negative so humid air stays out of locker rooms, lobbies and offices
  • Engineered equipment supports, roof curbs, permitting and crane lifts
  • Preventive maintenance agreements built around the pool season and the school schedule

Common Issues That Wreak Havoc on a Building Envelope

An indoor pool puts hundreds of pounds of water into the air every day. When the dehumidification and ventilation system falls behind, that moisture goes looking for the coldest surface it can find, and the building pays for it. These are the problems we see most often, and what we fix:

  • Condensation inside walls and roofsWarm, humid pool air reaches its dew point inside the wall or roof assembly and turns to water where no one can see it.
  • Roof deck and steel joist corrosionMoisture plus chloramines attacks the metal deck, joists, bolts and hangers above the pool.
  • Failed vapor barriers and wet insulationOnce the vapor retarder is breached, insulation soaks up water, loses its R-value and adds weight to the roof.
  • Mold and mildewHidden growth behind finishes, above ceilings and in duct insulation affects air quality and finishes.
  • Window and storefront condensationGlass fogs and frosts in winter, and water runs down to rot frames, sills and drywall.
  • Masonry damageMoisture driven into block and brick shows up as efflorescence, staining, spalling and freeze-thaw cracking.
  • Rusted ductwork, fixtures and fastenersDucts, diffusers, light fixtures and ceiling grids corrode, and ceiling tiles sag and stain.
  • Humid air escaping the pool roomWithout proper negative pressure, pool air pushes into locker rooms, offices and lobbies, damaging doors, finishes and electronics.
  • Dripping and ice at roof penetrationsCondensation at curbs, exhaust fans and duct penetrations is often mistaken for a roof leak.
  • Peeling paint and failed coatingsConstant moisture lifts paint and protective coatings, leaving steel and concrete exposed.
  • Chloramine buildup and poor air qualityToo little exhaust or outside air leaves the “pool smell” in the room, irritating swimmers and accelerating corrosion.
  • Unbalanced outside air and exhaustThe root of most of the above: a system that is not moving and drying the air the way the room needs.

Satisfied Customers

We are proud to keep these pools running for owners and operators who trust us with their swimmers, staff and buildings:

Saf-T-Swim

Bellmore, Bohemia, Commack, Coram, Deer Park, Levittown, Little Neck, Melville, New Hyde Park, Oceanside, Riverhead and Smithtown, NY

Goldfish Swim School

Brooklyn, Commack, Farmingdale, Garden City, Glendale and Staten Island, NY; Denville, Edison, Manalapan, Middletown and Wayne, NJ

YMCA of New Rochelle

Natatorium HVAC, New Rochelle, NY

Westchester Swim School

Westchester County, NY

The Ruby

Residential pool floor, Manhattan

Full System Replacements in Permitting

These projects are designed and filed, with applications pending permit release. Each is a full system replacement, engineered and permitted before a single cut is made.

Application pending permit release

Saf-T-Swim Smithtown

Full system replacement, including new corrosion-rated roof exhaust for the pool and chemical areas.

Application pending permit release

Saf-T-Swim Riverhead

Full system replacement with a new dedicated outdoor air system and new pool air distribution, coordinated with the architect’s drawings.

Application pending permit release

Saf-T-Swim Bohemia

Full system replacement, with the rooftop pool unit set on a new engineered curb and the roof framed and sealed for a signed-off installation.

Application pending permit release

Saf-T-Swim Levittown

Full system replacement with a new pool dehumidifier, exhaust fans, sensors and controls.

Application pending permit release

YMCA of New Rochelle

Full natatorium system replacement: new DOAS, pool and pump room exhaust, and controls, phased around the Y’s schedule.

We will add photos from each of these projects to our pool project photos as the work begins.

Is your pool room fighting you? Foggy windows, a strong chlorine smell, rust above the pool or a dehumidifier that never shuts off are all early warnings. Call 833-504-4822 (833-504-HVAC) or contact us to have Rich and our team evaluate your system.